Broome Restrainers

These popular Broome Restrainers provides fast and easy animal insertion. The cylindrical design of these Restrainers solves the problem of the rodents turning once they are introduced into the Restrainer.

To place the animal into the Restrainer, loosen white Derlin nose piece and grasp the animal by the tail. Slide the animal into the Restrainer by pulling its tail along the open groove until the animal is completely enclosed in the cylinder. Then slide the nose piece into the groove on the opposite side of the Restrainer and place it up to the nose of the animal.

Download:Broome Restrainers

Category: Pharmacology

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Broome Restrainers”

Related products

Student Double Tissue Bath

1              Capacity: 5 Liter with decent look

2              Heaters 120 Watts

3              A float switch provides a safety cut off should the water level fall

below the minimum permitted level,

4              Two modes for solution replacement emptying and filling

5              Each tissue chamber has an adjustable gas diffuser for oxygenation and

push toggle on the front of the unit control the filling and emptying of the

tissue chambers via toggle switch.

6              Perspex sheet wall thickness 10mm

7              Magnetic Stirrer for uniform temperature

8              The control system provides an LED display

9              Inner Tissue Bath Standard 25 ml Capacity Qty 2 with each Bath

10           Detachable Stem Tissue Vessel, supplied as standard,

for increased convenience when changing tissue vessels.

(The tissue chamber portion of the tissue vessel can be removed

without disturbing the stem or disconnecting the tubing for the warmed

perfusate and drainage.

11           Inner tissue bath Pyrex Material Graduated 25 ml Capacity

12           O ring provide 2 set

13           Warming Coil Round/Curve flat type

14           Power: 220 Voltages

Downlaod:Student Double Tissue Bath

Read more
Tissue Bath Sets 2

Digital temperature control

Temperature automatically held within 0.1oC

from 15o to 50oC in 0.1o increments

Large 11.2 liter Water Bath capacity for stable temperature in

Coils and Tissue Vessels

Magnetic stirrer ensures uniform bath temperature

250 watts off heating power for fast heat-up time

Flat Warning Coils lie flat against the sides of the tank,

leaving the center free for experimental procedures

Large capacity (400 ml) Flat Perfusate Warming Coils en-sure

a sufficient supply of temperature-controlled perfusate for the

mos lengthy assays

Detachable Stem Tissue Vessel,

supplied as standard, for increased convenience when changing

Tissue Vessels (The without disturbing the stem or disconnecting

the tubing for the warmed perfusate and drainage

Downlaod:Tissue Bath Sets 2

Read more
Basic Single Tisue Bath

The walls of this bath are made of heavy, transparent plastic, so that the specimen can be consultant and easily observed. The tank is 100mm in diameter by 125mm high (4 x 5 in) and has a capacity of 800ml. Tank is solidly cemented to the base, which is constructed of formed white plastic. The plastic base offers the double advantage of not only being corrosion proof, but also serving as an excellent electrical insulator from the heater. A drain hole with tubing and plug is located in the bottom of the tank. There is also a tapered plastic cone in the bank bottom, into which the soft rubber bung carrying the stem of the glass tissue bath fits, making a convenient leak proof joint. The water bath is heated by a simple, sturdy cartridge element that is mounted off-center through the bottom on the tank. This heater has a rating of 50 watts. The temperature is controlled by an energy regulator mounted on the front of the bath. The dial has a position for “full energy” while the bath is being brought up to its desired temperature. A hole in three corners of the base can be used for uprights.

Download:Basic Single Tisue Bath

Read more
Isolated Organ and Tissue 3

This Heated Water Bath is for the most demanding research work.

It has two heaters having 250 watts of combined power.

The temperatur is automatically controlled by a sensitive thermistor

in a metal tube inside the bat to hold the bath water

temperature has stabilized. A magnetic stirrer in the bottom of the

tank slowly circulates the water to ensue uniform temperature.

These heaters are mounted through the front of the tank near the

bottom and extend 100 mm (4 in) into it. The desired temperature of

the Water Bath is set by a dial on the front panel that is graduated

from 15o to 45o C in 5o increments.

Two on/off switches and indicator lamps, one for power and the other

for the magnetic stirrer are on the front panel.

Download:Isolated Organ and Tissue 3

Read more